Electric Actuators are offered in 3 Basic Types.
The LJ1 Series Single Axis
Actuator is available with 2 Types of guides ( High Rigidity Direct
Acting and Slider Type). There are 3 Types of Lead Screws Available
(Ground Ball Screw, Rolled Ball Screw and Slide Screw Type which offers
Low Noise 47-53dB).
LG1 Series is a Low Profile/Non-coupling Type with Reduced
Height and Length.
Low profile 55mm (35mm less than the LJ1H20), Reduced Length (62mm
shorter than the LJH20). A Series with Coupling is available and can
be used for non-standard motor mounting. There are 2 types of body
material. In addition to aluminum frames, stainless steel are available
for applications requiring more rigidity.
Series are Short Stroke Type Actuators offering 3 Guide
The LXF is a Space Saving Low Profile Slide Table with Stepper Motor.
The LXP is a Guide Rod Type Actuator with Stepper Motor for use as
The LXS is a High Rigidity Slide Table with Stepping Motor for High
Moment Loads. CE Marking is available as Standard. AC Servomotor specification
on a made to order basis.
Each Series have an
NC Machined Reference Plane and Positioning Pin Hole provided which
improves the repeatability of actuator body mounting.
Series Dedicated Controllers are for use with AC Servo
Motors (LC1 Series) Controller has built-in driver and can be programmed
via PC Software or using the LC1-1-T1 Teaching Box.
For Stepper Motors (LC6 Series) is DIN Rail Mountable and Controls
Positioning by Pulse Signal, The driver can be controlled by general
purpose PLC Positioning Unit or the LC6 Series Controller. With built-in
positioning (pulse) output function your movement pattern can be directly
specified by PLC with Reduces Your Design Requirements. When using
the Teaching Box up to 16 Units Can be Set.